Allied Telesis AT-8550SP User Manual
Page 52
Installation
52
Perform the following procedure to install the switch in a standard
19-inch rack. If you are not installing the switch in a rack, proceed to
Installing an Optional GBIC Module on page 56.
1.
Place the unit upside down on a level, secure surface.
2.
Using a flat-head screwdriver, remove the snap-on plastic feet from
the bottom of the switch, as shown in Figure 12.
Figure 12 Removing the Feet
3.
Turn the switch over.
4.
Attach a rackmounting bracket to one side of the switch using four
of the screws that came with the switch. You can install the brackets
in one of four ways, as shown in Figure 11.
5.
Install the second rackmounting bracket on the other side of the
switch using the four remaining screws.
6.
Mount the switch in the 19-inch rack using standard screws (not
provided).