Allied Telesis AT-S63 - Manual (Page 68)

Chapter 3: Basic Switch Commands
68 Section I: Basic Operations
disable the server, refer to “ENABLE TELNET” on page 47 and
“DISABLE TELNET” on page 46.
ˆ Telnet insert NULL - The status of the Telnet NULL parameter. When
ON, the Telnet server on the switch adds a NULL character after each
CR for those Telnet clients that require the character to display the
information correctly. When OFF, the default setting, no NULL
character is set after a CR. To set this feature, see “SET TELNET
INSERTNULL” on page 59.
ˆ MAC address aging time - The current value for the MAC address
aging timer. The switch uses the aging timer to delete inactive dynamic
MAC addresses from the MAC address table. To set this value, refer
to “SET SWITCH AGINGTIMER|AGEINGTIMER” on page 151.
ˆ Console startup mode - The management interface —menus or
command line — that initially appears when you start a local or remote
management session. The default is the command line interface. To
set the startup mode, refer to “SET SWITCH CONSOLEMODE” on
page 43.
ˆ Multicast Mode - The multicast mode, which determines the behavior
of the switch when forwarding ingress spanning tree BPDU packets
and 802.1x port-based access control EAPOL packets To set the
multicast mode, refer to “SET SWITCH MULTICASTMODE” on
page 447.
Example
The following command displays the switch information described above:
show switch