Allied Telesis AT-S63 - Manual (Page 30)

Chapter 1: Starting a Command Line Management Session
30 Section I: Basic Operations
Starting a Command Line Management Session
The command line interface is supported from a local management
session using the Terminal Port on an AT-9400 Series switch and a
remote Telnet or SSH management session. For instructions on how to
start a local or remote management session, refer to the AT-S63
Management Software Menus Interface User’s Guide.
The default management interface when you start a session is the
command line interface (CLI). The prompt differs depending on whether
you logged in as manager or operator. If you logged in as manager, you
will see “#.” If you logged in as operator, you will see “$.”
Note
Web browser interface does not support the command line interface.