Allied Telesis AT-S63 - Manual (Page 246)

Chapter 15: Event Log and Syslog Server Commands
246 Section II: Advanced Operations
syslogformat Specifies the format of the generated messages. The
possible options are:
extended Messages include the date, time, and
system name. This is the default.
normal Messages do not include the date, time,
and system name.
module Specifies what AT-S63 events to filter. The available
options are:
all Sends events for all modules. This is the
default.
module Sends events for specific module(s). You
can select more than one module at a
time, for example, MAC,PACCESS. For a
list of modules, see Table 12, “AT-S63
Modules” on page 249.
severity Specifies the severity of events to be sent. The
options are:
all Sends events of all severity levels.
severity Sends events of a particular severity.
Choices are I for Informational, E for Error,
W for Warning, and D for Debug. You can
select more than one severity at a time (for
example, E,W). For a definition of the
severity levels, see Table 13, “Event Log
Severity Levels” on page 251. The
defaults are I, E, and W.
Description
This command modifies an existing output definition. For further
information on the FACILITY and SYSLOGFORMAT parameters, see
“CREATE LOG OUTPUT” on page 232. For further information about the
MODULE and SEVERITY parameters, see “ADD LOG OUTPUT” on
page 230.
Note
This version of the AT-S63 management software supports only
syslog servers as output definitions.