Allied Telesis AT-S63 - Manual (Page 165)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 165
SHOW SWITCH TRUNK
Syntax
show switch trunk
Parameters
None.
Description
This command displays the names, ports, and load distribution methods of
the static port trunks on the switch. An example of the command is shown
in Figure 12.
Figure 12. SHOW SWITCH TRUNK Command
The command displays the following information:
ˆ Trunk group ID - The ID number of the static port trunk.
ˆ Trunk status - The operational status of the trunk. If the trunk has
established a link with the other device, status will be UP. If the trunk
has not establish a link or the ports in the trunk are disabled, status will
be DOWN.
ˆ Trunk group name - The name of the static port trunk.
ˆ Trunk method - One of the following load distribution methods:
SRC MAC Source MAC address.
DST MAC Destination MAC address.
SRC/DST MAC Source address/destination MAC address.
SRC IP Source IP address.
DST IP Destination IP address.
SRC/DST IP Source address/destination IP address.
ˆ Ports - The ports of the static port trunk.
Trunk group ID ............ 2
Trunk status ........... UP
Trunk group name ....... Server11
Trunk method ........... SRC/DST MAC
Ports .................. 12-16