Allied Telesis AT-S81 - Manual (Page 76)

Chapter 6: Port Trunking
76 Section I: Using the Menus Interface
The Trunk Configuration Menu is shown in Figure 16.
Figure 16. Trunk Configuration Menu
3. To add a trunk member, do the following:
a. From the Trunk Configuration Menu, type A to select Add Trunk
Member.
The following prompt is displayed:
Enter trunk group number>
b. Select a trunk group number from 1 to 4 and press Enter.
The following prompt is displayed:
Enter port members (up to 8 ports) for trunk n >
c. Enter the ports you want to include in the trunk and press Enter.
You can specify the ports individually separated by commas (for
example, 1,2,5), as a range of ports separated by a hyphen (for
example, 2-4), or both (for example, 1,3, 6-8).
4. To set the trunk status, do the following:
a. Type S to select Set Trunk Status.
The following prompt is displayed:
AT-8000/8POE Local Management System
Advanced Switch Configuration -> Trunk Configuration Menu
Group Status Port Members Trunk ID
------- -------------- --------------------- ----------
1 Disabled 1
2 Disabled 2
3 Disabled 3
4 Disabled 4
5 Disabled 5
6 Disabled 6
7 Disabled 7
----------------------- -----------------------------
[A]dd Trunk Member
[S]et Trunk Status
[R]emove Trunk Member [Q]uit to previous menu
Command>