Allied Telesis AT-S81 - Manual (Page 19)

AT-S81 Management Software User’s Guide
19
Local Connection
To establish a local connection with a switch, you connect a terminal or a
PC with a terminal emulator program to the terminal port on the front of the
switch using the management cable included with the unit. This type of
connection is referred to as “local” because you must be physically close
to the switch, such as in the wiring closet where the switch is located.
Note
For instructions on how to start a local management session, refer to
“Starting a Local Management Session” on page 26.
With a local connection, you can manage the switch using the menus or
CLI.
A switch does not need an Internet Protocol (IP) address for you to
manage it locally. You can start a local management session on a switch
at any time. It does not interfere with the forwarding of network packets by
the device.