Allied Telesis AT-S81 - Manual (Page 105)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 105
Creating a VLAN
This section contains the procedure for creating a new VLAN. This
procedure assigns the VLAN a name, a VID number, and the untagged
and tagged member ports.
After you have performed this procedure, you must configure the untagged
members of the VLAN by adjusting their PVID values to match the virtual
LAN’s VID number. The PVID value of a port must match its virtual LAN’s
VID in order for a port to be considered an untagged member of the VLAN.
This procedure is found in “Configuring the Port PVID” on page 108.
To create a VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 15 on
page 75.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu, which displays any existing VLANs, is
shown in Figure 21.
Figure 21. VLAN Management Menu
AT-8000/8POE Local Management System
Advanced Switch Configuration -> VLAN Management Menu
VLAN ID VLAN Name VLAN Type
------- --------------------- ----------
1 Default VLAN Permanent
3 Marketing Static
----------------------- ------------------------------------
[N]ext Page
[C]reate VLAN C[o]nfig VLAN Member
[P]revious Page [D]elete VLAN [S]et Port Config
[R]eset VLAN to Default [Q]uit to Previous Menu
Command>