Allied Telesis AT-FS705PD - Manual (Page 25)

AT-FS705PD Fast Ethernet Switch Installation Guide
17
Wall-Mounting the Switch
The switch can be mounted horizontally on a wall using the keyholes on the
bottom of the switch. The screws, plastic anchors, and other materials
necessary to mount the switch on a wall are not provided.
To wall-mount the switch, perform the following procedure:
1. If attached, remove the rubber feet, data cables, and power cord from the
switch.
2. Select a wall location for the device.
3. Install two plastic anchors and two screws onto the wall, as illustrated in
Figure 6.
Figure 6 Installing The Plastic Anchors and Screws Onto The Wall
A T-F S7 05 PD
5 Po rt Fa st Eth ern et Sw itc h
Po we re d D ev ice
100 M
5 4 3 2 1 LINK/A CT
FDX
PW R PO E WA LL