Allied Telesis AlliedView-EMS 3.10 VLAN MANAGER - Manual (Page 62)

6.14.2 Add/Modify VLAN Dialogs
The Add/Modify VLAN Dialogs have the following Input Fields:
Input Field Valid Values Length
Name (cannot be
modified)
If the software release version is 2.03 or lower:
•
•
•
•
•
Alphanumeric characters
Other characters except double quote (")
If the software release version is 3.03:
Alphanumeric characters
Underscore ("_")
Dash ("-")
1 - 32 characters
Identifier (cannot be
modified)
• 2 - 4094 -
Advertisement
(cannot be modified
if VLAN Type is
Protocol)
•
• Enabled
Disabled
-
6.14.3 Notes
•
•
•
The XFP slots on the device image will always show XFP images regardless of
whether or not XFP transceivers are physically present in the slots.
The current firmware version allows a maximum of 32 characters for the VLAN
Name parameter. When adding ports 1 and/or 2 as tagged/untagged ports of a
VLAN whose name is of length 32, an additional character is appended to the
name thereby causing the name to exceed 32 characters. When this happens,
problems may be encountered while attempting to modify or delete this VLAN.
The current firmware version allows you to pre-configure switches that may be
added to the stack in the future. Pre-configured switches are identified by a “Non-
Existing” label that appears above the device panel in the Add VLAN and Modify
VLAN dialog boxes. Ports on pre-configured switches can be included in a VLAN
but only those marked as “untagged” or “forbidden” will appear on the VLAN
Information Window. Ports marked as “tagged” will not appear. They will appear
only when a physical switch, whose box id matches the box id of the pre-
configured switch to which the tagged ports belong, is added to the stack.
AlliedView™-EMS 3.10 VLAN Manager User’s Guide Page 62 of 71