Allied Telesis AlliedView-EMS 3.10 VLAN MANAGER User Manual
Page 37
•
Ports or port channels that are General members of a VLAN and whose PVID is not
set to the default configuration (PVID=1) cannot be associated as Access/Trunk
members of another VLAN. Attempting to do so will result in the error message:
"Port
PVID."
•
During an Add/Modify VLAN operation, VLAN Manager processes and configures
ports and port channels sequentially. When an error is encountered, succeeding
ports and port channels are no longer processed. In a Modify VLAN operation, the
port or port channel on which the error occurred will be returned to its original
state.
•
Any attempt to modify the VLAN membership mode of a port or port channel that
is an Access/Trunk/General Untagged member of the Default VLAN to a
Trunk/General Tagged member or a Forbidden member will result in the error
message: "Forbidden or Tagged Member not allowed in Default VLAN."
•
After initiating a Restart operation, VLAN Manager will continuously attempt to
connect to the device for up to 1 minute until a connection is established. If a
minute has elapsed and connection has still not been established, an error message
will be displayed.
•
It may take a while for VLAN Manager to retrieve or save VLAN information
from/to the AT-8000S, especially if the device is in stack mode.
•
The current firmware version allows you to pre-configure switches that may be
added to the stack in the future. Pre-configured switches are identified by a "Non-
Existing" label that appears above the device panel in the Add VLAN and Modify
VLAN dialog boxes. Ports on pre-configured switches can be included in a VLAN
provided they are not members of a port channel. Any attempt to associate a pre-
configured switch port that is a member of a port channel to a VLAN will result in
the error message: "Port
6 Device Support
AlliedView™-EMS 3.10 VLAN Manager User’s Guide
Page 37 of 71