Allied Telesis AT-MC13 - Manual (Page 35)

AT-MC13 Media Converter Installation Guide
35
If the NORMAL LED on the AT-MC13 is OFF, do the following:
ˆ Check that the end-nodes connected to the media converter are
powered ON.
ˆ Check that the fiber optic cable is securely connected to the fiber
optic port.
ˆ Verify that the appropriate fiber optic cable is being used. Refer to
Table 4 on page 39 and Table 5 on page 39 for the fiber optic cable
specifications.
ˆ Verify that the maximum allowable loss budget for the fiber optic
cable has not been exceeded.
If you are still experiencing problems after troubleshooting the installation,
contact Allied Telesis Technical Support for assistance. Refer to
“Contacting Allied Telesis” on page 12 or visit our web site at
www.alliedtelesis.com for support information.