Allied Telesis AT-MC13 - Manual (Page 27)

AT-MC13 Media Converter Installation Guide
27
Installing an AT-MC13 Media Converter
The AT-MC13 media converter can be used on a desktop.
To use an AT-MC13 media converter on a desktop, perform the following
procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
Note
Do not remove the dust cover from the fiber optic port until you are
ready to connect the fiber optic cable. Dust contamination can
adversely impact the operating performance of the port on the
media converter.
2. If you are installing the media converter on a desktop, attach the four
protective feet (provided) to each corner of the base of the unit. Do
not attach the rubber feet if you are installing the unit in an AT-MCR1
or AT-MCR12 chassis.
3. If you are installing the media converter in an AT-MCR1 or
AT-MCR12 chassis, refer to the chassis’ installation guide for
instructions on how to install the unit.
4. Attach the four protective rubber feet to the bottom of the media
converter, as shown in Figure 9.
Figure 9. Attaching the Protective Feet
5. Place the media converter on a secure, level surface, leaving ample
space around the media converter for ventilation.
AT-MC13 ETHERNET MEDIA CONVERTER
NORMAL
LNK TST
10Base-FL 10Base-T TX RX
MDI MDI-X
PWR
NORMAL
REC
LINK
REC
LINK
CLASS 1
LED PRODUCT
1198