Allied Telesis AT-S82 User Manual
Page 19
AT-S82 Management Software User’s Guide
19
2. To set the switch’s IP address, in the Get IP Address field, choose
one of the following from the list:
Manual - Allows you to enter static IP address information:
a. In the IP Address field, enter the IP address. The default is
192.168.1.1.
b. In the Subnet Mask field, type the subnet mask for the switch. The
default is 255.255.255.0.
c. In the Default Gateway field, type the IP address of the default
gateway. There is no default gateway assigned.
BOOTP - Enables BOOTP so that the switch gets its IP address from a
BOOTP server. When you choose this selection, the IP Address,
Subnet Mask, and Default Gateway fields are not available.
DHCP - Enables DHCP so that the switch gets its IP address from a
DHCP server. When you choose this selection, the IP Address, Subnet
Mask, and Default Gateway fields are not available.
3. Click Apply to implement your changes.
Note
For BOOTP and DHCP options: In order to save this new
configuration, you must contact the switch using its newly acquired
IP address in order to perform steps 4 and 5 below. If the switch is
rebooted or power cycled before you save the configuration, the IP
address is reset to the factory default value of 192.168.1.1 and
Manual mode.
4. To save the settings to the configuration file, from the main menu,
select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 14.
5. Click Apply.