Allied Telesis AT-S63 - Manual (Page 356)

Chapter 23: 802.1x Port-based Network Access Control
356 Section VI: Port Security
Enabling or Disabling 802.1x Port-based Network Access Control
To enable or disable 802.1x Port-based Network Access Control, perform
the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Network Security option.
3. Select the 802.1x Port Access tab.
The 802.1x Port Access tab is shown in Figure 144 on page 354.
4. Click the Enable Port Access check box. A check in the box means
the feature is activated on the switch. No check means the feature is
disabled.
For instructions on configuring the accounting feature, refer to
“RADIUS Accounting” on page 369.
5. Click Apply.
A change to the status of 802.1x Port-based Network Access Control
is immediately implemented on the switch.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.