Allied Telesis AT-S63 - Manual (Page 224)

Chapter 17: SNMPv3
224 Section III: SNMPv3
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 82 on page 220.
4. Click Next or Previous to display the Access Table entry to be
deleted.
5. Click Remove.
A warning message is displayed. Click OK to remove the Access Table
entry.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 26.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 82 on page 220.
4. Click Next or Previous to display the Access Table entry to be
changed.
5. Click Modify.
The Modify SNMPv3 Access page is shown in Figure 84.