Allied Telesis AT-S63 - Manual (Page 156)

Chapter 13: Class of Service
156 Section II: Advanced Operations
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS
priorities to egress priority queues. To change the mappings, perform the
following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Services option.
3. Select the Queuing & Scheduling tab.
The Queuing & Scheduling tab is shown in Figure 52.
Figure 52. Queuing & Scheduling Tab (Configuration)
Note
The Configure Egress Weights section in the tab is explained in the
next procedure, “Configuring Egress Scheduling” on page 158.