Allied Telesis AT-S63 - Manual (Page 311)

AT-S63 Management Software Web Browser User’s Guide
Section IV: Spanning Tree Protocols 311
Resetting MSTP to the Default Settings
To reset MSTP to the factory default settings, perform the following
procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 120 on page 292.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 121 on
page 295.
5. Click Defaults.
The MSTP settings are returned to their default values.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.