Allied Telesis AT-TQ2403 - Manual (Page 17)

AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point Installation Guide 17
Note: Please be aware that a metal surface acts as a shield for radio signals. Therefore expect
little or no coverage at all behind metal surface.
Connecting the Access Point to the LAN
To connect the AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point to the LAN,
perform the following procedure:
1.
2.
3.
Locate the RJ45 cable in the box.
Connect one end of the cable to the LAN.
Connect the other end of the cable to the LAN port on the back of the access point, as shown in
Figure 7.
Figure 7: Attaching the LAN Cable
Powering On the Access Point
To power on the access point, perform the following procedure:
Warning: Do not work on equipment or cables during periods of lightning activity.
Warning: Power adapter is used as a disconnection device. To de-energize equipment,
disconnect the power adapter.
1. Do one of the following:
a. Plug the power adapter on the back panel, as shown in Figure 8, and plug the power adapter into
a wall outlet.
Figure 8: Connecting the Power Adapter
b. Plug a LAN cable from a unit that supports PoE into the LAN port, as shown in Figure 9. No other
power connection is required.