Allied Telesis AT-TQ2403 - Manual (Page 15)

AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point Installation Guide 15
Figure 3: Connecting Antennas
You can try repositioning antennas until you get the best signal strength.
Using the Access Point on a Desktop
You can place the AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point on a desktop
or other flat surface.
To place the AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point on a desktop,
perform the following procedure:
1.
2.
Turn the access point over so that the top is resting on a flat surface.
Attach the four rubber feet to the bottom of the access point as shown in Figure 4.
Figure 4: Attaching the Rubber Feet
3.
1.
2.
3.
4.
Turn the access point over and place it on a flat, secure surface such as a desk or table, leaving ample
space around the unit for ventilation.
Mounting an Access Point on a wall
To mount the AT-TQ2403 IEEE 802.11abgh, Dual Radio, Enterprise Wireless Access Point on a wall,
perform the following procedure:
Select a wall location and mark two holes locations for the anchors 98.425 mm (3.875 in.) apart.
At the two marked holes locations, pre-drill for the drywall anchors.
Install the anchors and drive the screws into the anchors leaving approximately 4.76 mm (.1875 in.)
exposed.
Align the keyholes on the back with the screw heads, as shown in Figure 5.