Allied Telesis AT-GS950/24 - Manual (Page 32)

Chapter 2: Installation
32
Installing the Switch in an Equipment Rack
To install the switch in a standard 19-inch equipment rack, perform the
following procedure:
1. If attached, remove the rubber feet using a flat-head screwdriver.
2. Install a bracket on one side of the switch using a Phillips screwdriver
and four of the rack-mount screws included with the switch. Figure 7
and Figure 8 illustrate installing the brackets on the AT-GS950/16 and
AT-GS950/24 Switches, respectively.
Figure 7. Attaching the Rack-Mount Bracket to the AT-GS950/16 Switch
Figure 8. Attaching the Rack-Mount Bracket to the AT-GS950/24 Switch
3. Repeat step 2 to attach the remaining bracket to the other side of the
switch.
16
761
24
743
23