Allied Telesis AT-2972T/2 - Manual (Page 88)

Chapter 7: Installing the Novell NetWare Driver Software
88
Verifying or Modifying Adapter Parameters
When an adapter configuration is saved, the NetWare install program
adds load and bind statements to the autoexec.ncf file. By accessing this
file, you can verify the parameters configured for each adapter, modify
them, or enter additional parameters.
Note
The Novell monitor program and the config command are also
useful for verifying driver configuration. For information on how to
use these programs, see the Utilities Reference in your Novell
NetWare online documentation.
The parameters that can be defined in the load statements are described
below:
Configuration Parameters for B57.LAN driver:
TxDescriptors=
This is to initialize Descriptor resources on the adapter
for transmits.
Min = 100
Max = 512
Default = 120
RxBuffers=
This is to pre-allocate receive ECBs & Receive adapter
resources. This setting may be affected by the NetWare
server maximum/minimum packet receive buffer settings.
Min = 32
Max = 1000
Default = 200
RxTicks=
This is to enable the use of batching receives within a
specific time period.
Min = 0, disabled
Max = 5000000, 5 seconds
Units are in micro seconds
Default value is 300
TxTicks=
This is to enable the use of a transmit "tick" threshold
interrupt within a specific time period.
Min = 0, disabled
Max = 5000000, 5 seconds
Units are in micro seconds
Default is 200