Opening advanced properties – Allied Telesis AT-2972T/2 User Manual
Page 54

Chapter 5: Setting Advanced Properties
54
Opening Advanced Properties
In most cases, the default property values available on the Advanced Tab
are appropriate although you can change any of the available options to
meet the requirements of your system. You must have Administrator
privileges to modify the driver software. After the driver software has been
installed, you can use the following procedures to verify or change the
adapter properties:
“Ethernet@Wirespeed™ (AT-2972/T2 only)” on page 57
“Interrupt Moderation” on page 59
“Large Send Offload Property” on page 61
“Receive Side Scaling” on page 64
“Speed & Duplex Mode” on page 65
“Wake Up Capabilities” on page 68
Note
After you upgrade the driver software, the Advanced Properties may
change.
Note
The procedures in the sections listed above may differ slightly if the
“Classic Start Menu” is set on your computer.