Allied Telesis AT-DC2552XS - Manual (Page 60)

Chapter 4: Installing the SFP+ and QSFP+ Transceivers and Cables
60
2. Remove the SFP+ direct attach cable from its shipping container and
store the packaging material in a safe location.
3. If you are installing the direct attach cable in a top SFP+ slot, position it
with the Allied Telesis label and tab facing up. If you are installing the
direct attach cable in a bottom slot, position the it so that the label and
tab are facing down.
4. Slide the direct attach cable into the slot until it snaps in place. See
Figure 30
Figure 30. Installing a SFP+ Direct Attach Cable
5. Repeat steps 1 through 4 of this procedure if you have other SFP+
direct attach cables to install.
6. If you have QSFP+ transceivers or QSFP+ MTHTP cables, go to
“Installing QSFP+ Transceivers and Cables” on page 61.