Asus Multimedia System S-presso User Manual

Page 79

4 - 2 5

A S U S S - p r e s s o b a r e b o n e s y s t e m

USB 2.0 Controller [Enabled]

Allows you to enable or disable the USB 2.0 controller.
Configuration options: [Enabled] [Disabled]

USB 2.0 Controller Mode [FullSpeed]

Allows you to configure the USB 2.0 controller in HiSpeed (480 Mbps) or
Full Speed (12 Mbps). Configuration options: [Full Speed ] [Hi Speed]

USB Mass Storage Device Configuration

USB Mass Storage Reset Delay [20 Sec]
Allows you to select the number of seconds POST waits for the USB
mass storage device after the start unit command. The message “No
USB mass storage device detected” appears if none is installed in the
system. Configuration options: [10 Sec ] [20 Sec] [30 Sec] [40 Sec]

Emulation Type [N/A]
When set to Auto, USB devices less than 530 MB will be emulated as a
floppy drive, and the remaining drives as hard drives. Forced FDD
option can be used to force an HDD formatted drive to boot as FDD
(for example, ZIP drive).

Number of seconds
POST waits for the USB
mass storage device
after start unit
command.

The Device and Emulation Type items appear only when USB storage
devices are installed.

USB Mass Storage Reset Delay [20 Sec]

No USB Mass Storage device detected

Device #1 N/A
Emulation Type [N/A]
Device #2 N/A
Emulation Type [N/A]
Device #3 N/A
Emulation Type [N/A]
Device #4 N/A
Emulation Type [N/A]
Device #5 N/A
Emulation Type [N/A]
Device #6 N/A
Emulation Type [N/A]

USB Mass Storage Device Configuration

4.4.6

Load MiniLoader [Disabled]

Enable this item if you want the system to always enter Instant ON.
Configuration options: [Enabled] [Disabled]

This manual is related to the following products:

S-presso