Asus Multimedia System S-presso - Manual (Page 38)

2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
2.11.1 2.11.1 2.11.1 2.11.1 2.11.1 Voltage selector Voltage selector Voltage selector Voltage selector Voltage selector
The PSU has a 115 V/230 V
voltage selector switch
located beside the power
connector. Use this switch
to select the appropriate
voltage according to the
voltage supply in your area.
If the voltage supply in your
area is 100-127 V, set the switch to 115 V.
Setting the switch to 115 V in a 230 V environment will seriously
damage the system!
The voltage selector is set to 115 V by default.
If the voltage supply in your area is 200-240 V, set the switch to 230 V.
a. Connect the 4-pin power plug to the power connector of the optical
disk drive.
b Connect the 4-pin power plug to the power connector of the VGA
card.
c. Connect the 4-pin power plug to the power connector of the hard disk
drive.
d. Connect the 4-pin 12 V and the 20-pin ATX power plugs to the
ATX12V and ATXPWR connectors, respectively. See page 3-7 for the
location of these connectors.
P o w e r s u p p l y u n i t p l u g s P o w e r s u p p l y u n i t p l u g s P o w e r s u p p l y u n i t p l u g s P o w e r s u p p l y u n i t p l u g s P o w e r s u p p l y u n i t p l u g s
c
d
b
a
d