Asus Multimedia System S-presso - Manual (Page 69)

4 - 1 5 4 - 1 5 4 - 1 5 4 - 1 5 4 - 1 5 A S U S S - p r e s s o b a r e b o n e s y s t e m A S U S S - p r e s s o b a r e b o n e s y s t e m A S U S S - p r e s s o b a r e b o n e s y s t e m A S U S S - p r e s s o b a r e b o n e s y s t e m A S U S S - p r e s s o b a r e b o n e s y s t e m
4.3.3 4.3.3 4.3.3 4.3.3 4.3.3 Primary and Secondary IDE Master/Slave; Primary and Secondary IDE Master/Slave; Primary and Secondary IDE Master/Slave; Primary and Secondary IDE Master/Slave; Primary and Secondary IDE Master/Slave;
Third and Fourth IDE Master
Third and Fourth IDE Master Third and Fourth IDE Master Third and Fourth IDE Master Third and Fourth IDE Master
While entering Setup, BIOS auto-detects the presence of IDE devices. There
is a separate sub-menu for each IDE device. Select a device item then press
to display the IDE device information.
The values opposite the dimmed items (Device, Vendor, Size, LBA Mode,
Block Mode, PIO Mode, Async DMA, Ultra DMA, and SMART monitoring) are
auto-detected by BIOS and are not user-configurable. These items show
N/A if no IDE device is installed in the system.
Type [Auto] Type [Auto] Type [Auto] Type [Auto] Type [Auto]
Selects the type of IDE drive. Setting to Auto allows automatic selection of
the appropriate IDE device type. Select CDROM if you are specifically
configuring a CD-ROM drive. Select ARMD (ATAPI Removable Media Device)
if your device is either a ZIP, LS-120, or MO drive.
Configuration options: [Not Installed] [Auto] [CDROM] [ARMD]
LBA/Large Mode [Auto] LBA/Large Mode [Auto] LBA/Large Mode [Auto] LBA/Large Mode [Auto] LBA/Large Mode [Auto]
Enables or disables the LBA mode. Setting to Auto enables the LBA mode if
the device supports this mode, and if the device was not previously
formatted with LBA mode disabled. Configuration options: [Disabled]
[Auto]
Block (Multi-sector Transfer) [Auto] Block (Multi-sector Transfer) [Auto] Block (Multi-sector Transfer) [Auto] Block (Multi-sector Transfer) [Auto] Block (Multi-sector Transfer) [Auto]
Enables or disables data multi-sectors transfers. When set to Auto, the
data transfer from and to the device occurs multiple sectors at a time if
the device supports multi-sector transfer feature. When set to Disabled,
the data transfer from and to the device occurs one sector at a time.
Configuration options: [Disabled] [Auto]
Primary IDE Master Select the type of
device connected to the
system.
Device : Hard Disk
Vendor : Maxtor 6Y080L0
Size : 81.9GB
LBA Mode : Supported
Block Mode : 16 Sectors
PIO Mode : 4
Async DMA : MultiWord DMA-2
Ultra DMA : Ultra DMA-6
SMART Monitoring: Supported
Type [Auto]
LBA/Large Mode [Auto]
Block (Multi-sector Transfer) M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
Smart Monitoring [Auto]
32Bit Data Transfer [Auto]