Asante Technologies 10NIC-PCITM - Manual (Page 32)

13 Click the OK button to complete the installation.
14 Restart the computer.
Microsoft Windows NT Workstation or Server 4.0
This section shows you how to install the driver to use your adapter with
Microsoft Windows NT 4.0. The instructions assume that you have previ-
ously installed Windows NT 4.0 software on your computer.
1 Start Windows NT 4.0, then click the Start button.
2 Open the Settings menu and select Control Panel .
3 Double-click the Network icon.
4 If you have previously installed a network adapter in the
computer:
❏ Click Adapters in the Network window.
❏ Click Add.
If you have not installed a network adapter in the computer:
❏ Click Yes in the Network Configuration box.
❏ Select Wired to the Network in the Network Setup Wiz-
ard window.
❏ Click Next to continue.
❏ Click Select from list .
5 Click Have Disk in the Select Network Adapter window.
6 The Insert Disk window appears.
7 Insert the Driver Disk into the floppy drive.
8 Type the following at the prompt: A:\NT351&40
9 Click OK.
The Select OEM Option window appears.
10 Select Asanté 10NIC-PCI adapter , then click OK.
11 Select AutoSense in the Connection Type field.
D
Note: Make sure the Network Address field is empty.
The driver will automatically use the network address
that is stored in the PROM of the adapter.