ADC Campus-REX RS Interface Card User Manual
Page 83
Configuring with an ASCII Terminal
Campus-REX RS Interface Card User Manual
5-7
The following SNMP parameters must be set to manage the Campus-REX
over an SNMP network:
•
SNMP Read Only Comm String provides the authentication string used
for SNMP read-only operations
•
SNMP Read Write Comm String provides the authentication string used
for SNMP read-write operations
You can also set the Campus-REX to perform authentication error trap
generation. To enable this feature, do the following:
•
Set the Authentication Trap Status to Enabled or Disabled.
•
Enter the IP Address for the first Trap Receiver.
•
Enter a comm string for the first Trap Receiver.
•
Enter the IP Address for the second Trap Receiver.
•
Enter a comm string for the second Trap Receiver.
To configure the SNMP parameters:
1
From the Main Menu, type
then press
. The Data Port Settings
menu displays.
2
ENTER
Dec 9, 1999
ADC DSL SYSTEMS INC., CAMPUS RS, Version x.xx
13:16:44
Local Unit ID:
Campus-REX Unit #34
Local I/F:
REX
Remote Unit ID: Campus-REX Unit #12
Remote I/F: REX
Circuit ID:
Network Extension Circuit 5001
DATA PORT SETTINGS
MAC ADDRESS:
00:20:A7:21:2F:6B
10 BASE-T STATUS:
Up
1)
BRIDGE/ROUTER CONFIGURATION
2)
SNMP CONFIGURATION
3)
WRITE NVRAM
4)
RESET INTERFACE CARD
WARNING:
NVRAM must be written and interface card reset for any
configuration changes to take effect.
(R)eturn
ENTER CHOICE>
CAD1069i5.book Page 7 Thursday, May 30, 2002 7:32 AM