Samsung SWD-M100ZKECLW - Manual (Page 114)

111
3. Connect one end of the USB data cable (included with your
device) into the USB port on your computer.
4. Connect the other end into the Power/USB Data jack on the
left side of the device. For more information, refer to
“Enabling the Phone as Modem (PAM) Mode” on
page 108.
5. Launch the mWiMAX Connection Manager application.
Important!: You must install the correct carrier’s Connection Manager
application to obtain a valid connection. If you can not connect or
you receive either an “Account not valid” or “User information
not recognized” message, you will need to uninstall the
Connection Manager application and verify you are re-installing
the correct executable.
For more information, refer to “Installation of the Connection
Manager Application” on page 108.
6. From your computer, click Start > Programs (All Programs)
> Samsung Electronics > SWD-M100 > mWiMAX SWD-M100
Connection Manager.
– or –
Launch the M100 Connection Manager shortcut ( )
from your Desktop.
Note: After completing a frequency scan, you may receive a “No Coverage
area” message if you are not currently within a WiMAX coverage area.
7. Click Connect and confirm you are connected to the
Internet via your service provider’s WiMAX network.
• Confirm an active connection and signal strength via the
Connection Manager popup. This popup screen can be minimized
and hidden within the icon tray area.
• Click Disconnect to end your connection to the WiMAX network.
USB-WiMAX Internet USB-Data Connection
SWD-M100.book Page 111 Monday, March 8, 2010 8:09 AM