Samsung DVD-VR335-XAA - Manual (Page 64)

64 - English
R
ecording
Concerning Copy Control Signals
TV broadcasts that contain copy control signals may have
one of the following three signal types, Copy-Free, Copy-
Once and Copy-Never. If you want to record a copy-once
type program, use DVD-RW with CPRM in VR Mode or
DVD-RAM discs.
Once “Copy Once” has been recorded, additional recording
cannot be performed.
* compatible with CPRM.
- Content Protection for Recordable Media (CPRM)
CPRM is a mechanism that ties a recording to the
media on which it is recorded. It is supported by some
DVD recorders, but not by many DVD players. Each
blank recordable DVD has a unique 64-bit media ID
etched in the BCA(Burst Cutting Area). When protected
content is recorded onto the disc, it can be encrypted
with a 56-bit C2 (Cryptomeria) cipher derived from the
media ID. During playback, the ID is read from the BCA
and used to generate a key to decrypt the contents of
the disc. If the contents of the disc are copied to other
media, the ID will be absent or wrong and the data will
not be decryptable.
Recording the Current
Channel you are watching
1. Check to make sure the antenna cable is connected.
2. Check the remaining time on the disc.
DVD-RAM/DVD±RW/+R discs should be formatted or
initialized in advance before beginning recording.
(See page 63.)
1 Press the OPEN/CLOSE button and place a
recordable disc on the disc tray.
2 Press the OPEN/CLOSE button to close the disc
tray.
Wait until “LOAD” disappears from the front panel
display.
3 Press the CH/TRK ( / ) buttons or number
buttons to select the channel you want to record.
4 Press the REC SPEED button repeatedly, to select the
recording speed (quality).
• XP(High, approx. 1 hour)
➝ SP(Standard,
approx. 2 hours)
➝
LP(Low, approx. 4 hours)
➝ EP(Extended Play, approx. 6 hours/8hours)
5 Press the REC button.
• “ ” is displayed on the screen and recording
begins.
6 Press the STOP button to stop or finish a recording
in progress.
• The message “Updating the information of disc.
Please wait for a moment” is displayed.
Pausing / Resuming
• Press the REC PAUSE button to pause a recording
in progress.
• Press the REC PAUSE button again during pause to
resume recording.
• You can switch channels by pressing the CH/TRK
( / ) buttons while recording pauses.
Recording will stop automatically if there is
no free space left for recording.
Up to 99 titles can be recorded onto a DVD-
RAM/-RW/-R disc, and up to 48 titles onto a
DVD+RW/+R disc.
If the power is interrupted due to power fail-
ure or other reasons, the title being recorded
will not be saved onto the disc.
Recording will stop automatically if a copy
protected image is selected.
Do not use DVD-R authoring discs with this
unit.
Note
-RW
VR XP CH6
Recordable Time 00:26
Copy-Free Copy-Once Copy-Never
DVD-RW(Ver.1.1) O - -
DVD-RW(Ver.1.1)
with CPRM
VR mode
O O* -
DVD-R O - -
DVD-RAM(Ver.2.0) O O* -
DVD+R O - -
DVD+RW O - -
00995E-VR335_XAA-Eng2 2006.4.3 8:38 PM Page 64