Samsung BD-H6500-ZA - Manual (Page 25)

25
English
04
Settings
| NOTE |
\ The upgrade is complete when the product turns
off, and then turns on again by itself.
\ Samsung Electronics shall takes no legal
responsibility for product malfunction caused by
an unstable Internet connection or consumer
negligence during a software Update.
\ If you want to cancel the upgrade while the upgrade
software is downloading, press the v button.
\ When a system upgrade is in progress, "UPDATE" is
displayed on the front panel.
Update Now
You can use Update Now to update the
software through your network connection
or by using a USB flash drive. The network
instructions are below. The USB flash drive
instructions are on the next page.
1. Select Update Now, and then press the
v button.
The Update now pop-up appears.
2. The product searches on line for the latest
software version.
3. If it finds a new version, the Update
Request pop-up appears.
4. Select OK. The product upgrades the
software, turns off, and then turns on
automatically.
5. If you do not select OK or Cancel in one
minute, the product stores the new
upgrade software. You can upgrade the
software later using Auto Update.
6. If you select Cancel, the product cancels
the upgrade.
| NOTE |
\ When the system upgrade is done, check the
software details in the Product Information section
of the Contact Samsung screen.
\ Do not turn off the product during the Software
Update. It may cause the product to malfunction.
Auto Update
You can set the Auto Update function so that
the product downloads new upgrade software
when it is in Auto Update mode.
In Auto Update mode, the product is off, but
its Internet connection is active. This allows
the product to download upgrade software
automatically, when you are not using it.
1. Press the ▲▼ buttons to select Auto
Update, and then press the v button.
2. Select On. Then the product will be
updated automatically after power off. If
it downloads new upgrade software, the
product will ask you if you want to install
it when you turn the product on.
| NOTE |
\ To use the Auto Update Mode Upgrade function,
your product must be connected to the Internet.
Update by USB
To upgrade by USB, follow these steps:
1. Visit www.samsung.com.
2. Click SUPPORT on the top right of the
page.
3. Enter the product's model number into
the search field. As you enter the model
number, a drop down will display products
that match the model number.
4. Left click your product's model number in
the drop down list.
5. On the page that appears, scroll down
to and then click Firmware Manuals &
Downloads.
6. Click Firmware in the center of the page.
7. Click the ZIP button in the File column on
the right side of the page.
8. Click Send in the first pop-up that
appears. Click OK in the second pop-up
to download and save the firmware file to
your PC.