Samsung BD-H6500-ZA - Manual (Page 22)

22
English
Settings
Ğ
Wired - Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set
the Network Settings values manually.
Follow Steps 1 and 2 in Wired - Automatic,
and then follow these steps:
1. Select Network Status. The product
searches for a network, and then displays
the connection failed message.
2. On the bottom of the screen, select IP
Settings, and then press the v button.
The IP Settings screen appears.
3. Select the IP Setting field, and then press
the v button.
4. Select Enter manually in the IP Setting
field, and then press the v button.
5. Select a value to enter (IP Address, for
example), and then press the v button.
Use the number keypad on your remote
control to enter the numbers for the value.
You can also enter numbers using the
▲▼ buttons. Use the ◀▶ buttons on the
remote control to move from entry field
to entry field within a value. When done
with one value, press the v button.
6. Press the ▲ or ▼ button to move to
another value, and then enter the
numbers for that value following the
instructions in Step 5.
7. Repeat Steps 5 and 6 until you have filled
in all values.
| NOTE |
\ You can get the Network values from your Internet
provider.
8. When finished entering all the values,
select OK, and then press the v
button. The product verifies the network
connection and then connects to the
network.
Wireless Network
You can set up a wireless network connection
in four ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
- WPS(PIN)
When you configure the wireless network
connection, any wireless network devices
currently connected through the product
or, if applicable, the product's current wired
connection, will be disconnected.
Ğ Wireless - Automatic
1. In the Home screen, select Settings, and
then press the v button.
2. Select Network, and then press the v
button.
3. Select Network Settings, and then press
the v button.
4. Select Wireless in the Network Settings
screen, and then press the v button. The
product searches for and then displays a
list of the available networks.
Network Settings
Select your network type.
Wireless network
iptime23
iptime
solugen_edu#2
Network type Wireless
Refresh WPS(PBC)
You can connect your Blu-
ray player to the internet.
Please select which wireless
network to use.
5. Select the desired network, and then press
the v button.
6. On the Security screen, enter your
network's Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter
letters by selecting a letter with an arrow
button, and then pressing v button.