Maximum Wireless Mini-Max - Manual (Page 2)

Page 2
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
MINI-MAX
INSTALLATION
WIRELESS
TEST
BUTTON
TEST LIGHT
L IN
A L K A
E
L
L
A
K
A
IN
E
4
TRANSMITTER
Test the transmitter by depressing the test button. After a few seconds
the test light should blink RED every four seconds. This indicates that
the transmitter is in test mode, which lasts for 15 minutes. At the end of
15 minutes the transmitter will return to normal operating mode. After
initial power up, the indicator light on the receiver should blink GREEN
every four seconds. This indicates proper communication between the
receiver and the temperature transmitter.
(NOTE: If more than 15 minutes has passed since the button on the
temperature transmitter was pushed, it will need to be pushed again.)
The light on the receiver will blink other colors when different sensors
are installed.
GREEN
RECEIVER
INDICATOR
ORANGE
RED
GREEN
TRANSMITTER
RED
GREEN
ORANGE
....................WIND
................RAIN
.........TEMPERATURE
2 1
OUT GND N I 5 4 3
RECEIVER
12 VOLT
POWER SUPPLY
5
Once the transmitter has been activated, the default temperature
reading of approximately 32 should be replaced by a present
temperature reading. Refer to the troubleshooting section if a
present temperature reading does not appear.
6
Replace the plastic battery cover. Make
sure to seat the cover properly over the
glued in gasket.
COVER ALKALINE
LK A IN E A L
TEMPERATURE
SENSOR
RED