Maximum Cronus - Manual (Page 2)

INC.
30 Samuel Barnet Boulevard
New Bedford, Massachusetts 02745
(508) 995-2200 www.maximum-inc.com
TIME
1. Make sure Cronus is displaying time.
2. Push the switch to “Set” and hold it for about three seconds to start the time setting mode.
The hours digits will be blinking to indicate that they can be set.
3. To set the hour, push the switch to “Set” and let it return to the middle. The hour will advance
by one, if the hour is 11:00PM (23:00) it will advance to 12:00AM (0:00).
4. Push the switch to “Select” to move to the minutes tens digit.
5. Push the switch to “Set” to change the number.
6. Repeat steps 4 and 5 for the minutes ones digit.
7. Push the switch to “Select” and the final digit will stop flashing.
- If you need to change any of the values, simply push the switch to “Select” and move
through the digits again.
- If you are done setting the time, push the switch to “Set”. Cronus will exit the time setting
mode and resume the normal time display.
DATE
1. Make sure Cronus is displaying date.
2. Push the switch to “Set” and hold it for about three seconds to start the date setting mode.
The tens digit of the month, will be blinking to indicate that it can be set.
3. To set the tens digit, push the switch to “Set” and let it return to the middle. The number will
advance by one; if the number is nine then it will advance to zero.
4. Push the switch to “Select” to move to the months ones digit.
5. Push the switch to “Set” to change the number.
6. Repeat steps 4 and 5 for the date tens and ones digits.
7. Push the switch to “Select” and the final digit will stop flashing.
- If you need to change any of the values, simply push the switch to “Select” and move
through the digits again.
- If you are done setting the date, push the switch to “Set”. Cronus will exit the date setting
mode and resume the normal date display.
TIDE
You need to set Cronus to the next tide that will occur at your location.
1. Push the switch to “Set” and hold it for about six seconds to start the tide setting mode. After
about three seconds the date or time setting mode will start, DO NOT release the switch.
Once the tide setting mode has been started, the high or low tide LED, will be blinking to
indicate that it can be set.
2. First you must tell Cronus whether the next tide is a high or low. To set the tide LED, push the
switch to “Set” and let it return to the middle. The other LED will light.
3. Push the switch to “Select” to move to the hours digits.
4. Push the switch to “Set” to change the number.
5. Repeat steps 4 and 5 for the minutes tens and ones digits.
6. Push the switch to “Select” and the final digit will stop flashing.
- If you need to change any of the values, simply push the switch to “Select” and move
through the digits again.
- If you are done setting the time of the next tide, push the switch to “Set”. Cronus will exit the
tide setting mode and resume the normal display.