Campbell Scientific 03002, 03101, and 03301 R. M. Young Wind Sentry Sensors - Manual (Page 16)

R.M. Young Wind Sentry
7.2 Assembly and Mounting .2 Assembly and Mounting
Tools required: Tools required:
• 5/64” Allen wrench • 5/64” Allen wrench
• Allen wrench provided with sensor • Allen wrench provided with sensor
• 1/2” open end wrench • 1/2” open end wrench
• compass and declination angle for the site (see Appendix A) • compass and declination angle for the site (see Appendix A)
• small screw driver provided with datalogger • small screw driver provided with datalogger
• UV resistant cable ties • UV resistant cable ties
• small pair of diagonal-cutting pliers • small pair of diagonal-cutting pliers
• 6 - 10” torpedo level • 6 - 10” torpedo level
7.2.1 03002 Wind Sentry Set 7.2.1 03002 Wind Sentry Set
The 03002 mounts to a standard 1.0 in. IPS schedule 40 pipe (1.34 in. O.D.).
A 12” long mounting pipe ships with the 03002. The mounting pipe typically
fastens to a CM200-series crossarm via the CM220 mount or 17953 NU-RAIL
fitting. Section 4, Quickstart, describes mounting the 03002 using a CM220
mount or a 17953 NU-RAIL fitting. The 03002 can also be mounted at the top
of a CM110, CM115, or CM120 tripod with the CM216 (see FIGURE 7-1). The 03002 mounts to a standard 1.0 in. IPS schedule 40 pipe (1.34 in. O.D.).
A 12” long mounting pipe ships with the 03002. The mounting pipe typically
fastens to a CM200-series crossarm via the CM220 mount or 17953 NU-RAIL
fitting. Section 4, Quickstart, describes mounting the 03002 using a CM220
mount or a 17953 NU-RAIL fitting. The 03002 can also be mounted at the top
of a CM110, CM115, or CM120 tripod with the CM216 (see FIGURE 7-1).
FIGURE 7-1. The CM216 allows an 03002 or 03101 to mount atop the
mast of a CM110, CM115, or CM120 tripod
Fits in Mast
7.2.2 03101 Anemometer
Install the cupwheel to the anemometer shaft using the Allen wrench provided
with the sensor.
The 03101 mounts to a threaded 0.75 in. IPS schedule 40 pipe (1.05 in. O.D.).
A 10 in. long mounting pipe ships with the 03101. The mounting pipe
typically fastens to a CM200-series crossarm via the CM220 mount (see
FIGURE 4-1 in Quickstart) or 1049 NU-RAIL fitting (FIGURE 7-2). The
10