Chatsworth Products Hot Aisle Containment - Manual (Page 31)

Aisle Containment Manual, Rev. 2.0 ___ June 2013
Chatsworth Products 31
12. Starting at one end of aisle, install a panel onto the containment frame with the corrugate
ribs oriented laterally across aisle. 1 The panel should overlap the end header flange
approximately 1 ”. On edge opposite the aisle header, install the lateral aluminum extrusion
beam onto the poly panel. 2 Attach the gusset brackets to the frame beam as shown. 3
If required, trim the panels with a knife and a straight edge. For best results, use specialized
cutting tools like the Guardian Knife Guide and Coro-
Claw™ by Saw Trax Mfg. Inc., to cut
across or with the ribs respectively.
13. Assemble the cap plates into the ends of the telescoping cover as shown below. Note
orientation of M8 carriage bolts. Leave the bolts finger tight such that the cap plates
may be adjusted during assembly.