Flytec 6015 * - Manual (Page 21)

Operation Manual Flytec 6015
19
3.3.1 Display of actual coordinates
If the 6015-GPS
receives satellites by GPS-Receiver, the actual position is displayed in the
information field of the instrument by briefly pressing the key
i
Info.
After 20 sec. the previous display screen will automatically reappear. This function is useful in
relaying your location to some person after landing for your pick-up from there. Also when entering
a Waypoint with
WP OK Memorise Pos. the coordinates are displayed.
3.3.2 Memorising the actual position
It may happen from time to time that the current position
should be saved as a Waypoint. For this purpose the
WP key should be pressed for 3 seconds and subsequently
⇒ OK Memorise Pos. In response a beep will chime and the
momentary coordinates shall be saved in the memory as a
waypoint.
As the Waypoint name the 6015-GPS uses the letter W
(for Waypoint) followed by the actual date and the time of
day in UTC.
Example: W220409 111645 stands for 22nd April at
11 hours 16 min 45 sec (UTC).
F1 Goto
F2 Route
OK Pos WP
Naturally this Waypoint name may later be amended into a
more meaningful name, for ex. „Fiesch Airfield".
(see keypad functions 3.3.3.2)
3.3.3 Waypoints, alter, delete or adding
Waypoints can be managed and edited in the Main menu Waypoints. (Menu Waypoints)
3.3.3.1 Edit
Waypoints
Waypoints
> Edit
> Delete all
By briefly pressing the OK key access is given to the menu
Edit WP.
By use of the keys ▲up or ▼down a WP can be selected.
F1 = adding WP
Using the F1 it is possible to create a new Waypoint.
(see keypad functions 3.3.3.2). By use of the OK key the new
waypoint is memorised and added to the WP list in alphabetical order.
In total 200 WP can be saved in the 6015-GPS.
F1 WP F2 7
>Flytec
>Stanserhorn
F2 = Delete actual WP
Pressing the F2 key (Del WP) enables the delete function.
F1 WP F2 7
>Flytec
>Stanserhorn
Remark: deleting a WP is performed immediately without further
query!
OK key = modify WP characteristics
After pressing the OK key it is possible to edit in this order the name,
the coordinates, the altitude and the cylinder circumference.
(see under keypad functions).