ROHM RGP Long stroke gripper - Manual (Page 12)

Servicing, Maintenance of the parallel gripper
Parallel Long Stroke Gripper RGP
Id.1140167 Operating Instructions RGP
Röhm-Tool GmbH, Röhmstr. 6, 89407 Dillingen/Donau, GERMANY, Tel. (49)9071/508-0
Page 12 of 14
Servicing:
Most of the servicing work is required at very large intervals (approx. every 5 million cycles). However, at
the latest when it starts to become difficult to move the gripper and the clamping force drops, take the
gripper off the machine and clean it thoroughly.
To do so, dismantle the gripper down to its individual parts and check the parts for wear. Clean the parts
and reassemble after having repaired any defective parts and relubricate it with special grease. It is ad-
visable to replace the dynamically loaded sealing elements. For this reason, a set of the wearing parts
and sealing elements marked in the parts list should be available for such a case.
When assembling the gripper, take care to ensure that the marked parts are placed back in the intended
position.
Please be advised that only ORIGINAL spare parts or parts from authorised suppliers authorized may be
used. Any liability shall cease to exist for all damage caused by the use of foreign components.
Important: In order to be able to handle any orders of spare parts or individu-
al parts easily, the six-digit identification number engraved in the
component and the manufacturing number - if available - have to
be stated. The manufacturing number consists of two digits and a
consecutive number, attached to the identification plate or in the
direct vicinity of the identification number.
Address of the manufacturer: Firma
R ÖHM GmbH
Röhmstr. 6
89407 Dillingen/Donau
GERMANY