Siemens 36inc Stainless Gas Cooktop - Manual (Page 4)

and usage
4
1 - For safety reasons, do not allow the flames
to extend beyond the edge of the cooking
appliance.
2 - Remember that the appliance heats up
when in use. Remember to use common
sense. The absence of a flame does not
mean that the appliance parts are no longer
hot.
3 - For safety reasons, this appliance should
4 - Make sure the power supply is
disconnected before dismantling the
appliance.
6 - Do not block the combustion or ventilation
air flow.
7 - Maintain a minimum distance of 762 mm
installed in the upper part.
8 - The gas pressure regulator supplied with
10 - Important: When using an especially
large pan, leave a minimum space of 50 mm
(2") to prevent damage to countertops of
wooden, plastic or other non-heat resistant
materials. Never leave hot oil or grease
unattended.
safety of the appliance, use of high-pressure
steam jet cleaning apparatus is forbidden.
For US installations only:
This installation must comply with local
Gas Code, ANSI Z 223.1/NFPA 54, current
edition.
If an external electrical source is used, the
appliance must be electrically grounded in
exists, the National Electrical Code
ANSI/NFPA 70, current edition.
For Canada installations only:
The installation must comply with CAN 1-
B149.1 and .2- Installation Codes for Gas
When installed, the appliance must be
electrically grounded in compliance with local
legislation, or if none exists, in compliance
with CSA Standard C22.1-Canadian Electrical
Code, Part I (current).
This appliance may not be used in mobile
housing, recreational vehicles or
motorhomes.
ve must be disconnected from the gas supply
9 - The appliance and its individual shutoff val-
of the system at test pressures in excess of
piping system during any pressure testing
isolated from the gas supply piping system
by closing its individual manual shutoff valve
during any pressure testing of the gas supply
piping system at test pressures equal to or
The name plate is affixed to the
3.5 kPa (1/2 psig). The appliance must be
less than 3.5 kPa (1/2 psig).
For Massachusetts installations:
1. Installation must be performed by a
2. Shut-off valve must be a "T" handle gas
cock.
longer than 36 inches.
3. Flexible gas connector must not be
installation
Important information for
not be used for room heating purposes.
5 - Do not store combustible materials,
such as gasoline, other vapors and
inflammable liquids near the appliance.
the appliance must be installed in the gas
piping line.
grease unattended.
12 -To avoid compromising the electrical
underside of the appliance.
This appliance has been tested in
accordance with ANSI/CSA Z21.1 Standard
for household Cooking Appliances (USA)
and CAN 1.1-M81 (Canada)
codes, or if none exists, the National Fuel
compliance with local codes, or if none
Burning Appliances and or local codes.
(30") between the gas cooktop and cabinets
11 - Make the caution about leaving oil or
qualified or licensed contractor, plumber or
gas fitter qualified or licensed by the state,
province or region where this appliance is
being installed.