Siemens TK76K573 - Manual (Page 55)

53
de en
If there is not enough descaling
luid in the water tank, the follow­
ing message is displayed:
Not enough descaling fluid
Refill fluid
Pour lukewarm water into the empty
water tank (12) up to the calc (0.5 litre)
mark and dissolve two descaling tab­
lets in it. Press start stop (8). The
descaling programme will continue.
Clean and refill water tank » Start
Rinse the water tank and reill it with
fresh water up to the “max” mark.
Press start stop (8).
The descaling programme will now run
for about 1 minute:
Descaling
The cleaning programme then runs
for about 6 minutes and rinses the
appliance:
Cleaning
Empty drip tray
Empty the drip tray.
Replace drip tray
Replace the drip tray.
Replace the ilter if one is being used.
The appliance is ready for use again.
Important: Wipe down the appli­
ance using a soft, damp cloth to
immediately remove any descaler
residue. Such residue can cause
corrosion. New sponge cloths may
contain salts. Salts can cause rust
ilm on stainless steel and must
therefore be washed out thor­
oughly before use.
Accessories, storage,
disposal, guarantee
Accessories
The following accessories are available
from retailers or customer service:
Accessories Ordering number
Retail Customer
service
Cleaning
tablets
TZ60001 310575
Descaling
tablets
TZ60002 310967
Water ilter TZ70003 467873
Storage
To avoid frost damage during transport and
storage, the appliance must be completely
emptied irst.
Before emptying it as follows, the
appliance must be ready for use
and the water tank (12) illed.
1. Place a large, narrow receptacle under
the milk frother (10).
2. Select the Milk froth setting on the
display, press start stop (8) and
release steam for about 15 seconds.
Milk froth
3. Switch the appliance off at the power
switch O/I (1).
4. Empty the water tank (12) and the drip
tray (20).
TK76K573_Heft1.indb 53 25.11.2011 16:02:13