Siemens TK76K573 - Manual (Page 47)

45
de en
Empty the container. The appliance is
ready to use once more.
Rinsing the i lter simultaneously activates
the setting for the Service - change filter
display.
The i lter is no longer effective when the
Service - change filter display appears,
or at the latest after two months. It needs to
be replaced for reasons of hygiene and so
that there is no build­up of limescale (this
could damage the appliance). Replacement
i lters can be obtained from retailers or cus­
tomer service (see “Accessories”).
After every i lter change the i lter must i rst
be rinsed. Proceed as described at the be­
ginning of this section.
If no new i lter is used, turn the water i lter
setting to Off .
You can i nd detailed information about the
water i lter in the enclosed i lter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the i lter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
Further entries in the Settings menu:
> Descaling program : If you want
to descale the appliance, press start
stop (8) and run the descaling programme
(see “Descaling”).
> Cleaning program : If you want
to clean the appliance, press start
stop (8) and run the cleaning programme
(see “Cleaning”).
> Calc‘n‘Clean : If you want to
descale and clean the appliance at the
same time, press start stop (8)
and run the Calc‘n‘Clean programme
(see “Calc‘n‘Clean“).
> Factory settings : You can cancel
your own settings and reset the factory set­
tings. To activate the factory settings, press
start stop (8).
The appliance can also be reset to
the factory settings as follows:
1. Switch the appliance off fully at the
power switch O/I (1).
2. Press < and > (3) at the same
time, hold them down, and switch the
appliance on again at the power switch
O/I (1).
The factory settings are reactivated.
Set per­cup quantity
The per­cup quantity can be adjusted
individually to suit your cups. It can be set
separately for each type of drink and each
cup size.
1. To call up the default settings, keep
i (7) depressed for at least
3 seconds.
2. Select Per-cup quantities with >
3. Press start stop (8).
4. Select the type of drink with the rotary
knob (4).
5. Press > .
6. Select the cup size with the rotary knob
(4).
7. Press > .
8. Set the per­cup quantity with the rotary
knob (4).
< returns you to cup size and drink
selection. To quit the default settings, press
i (7). The settings are stored.
When the cup size is selected, the changed
per­cup quantity is shown graphically:
1x * 1x + Coff ee
Per­cup quantity reduced compared
with standard setting
Per­cup quantity increased compared
with standard setting
Standard
TK76K573_Heft1.indb 45 25.11.2011 16:02:06