Matrix Orbital GLK24064-16-1U - Manual (Page 32)

27
7.6 Set Auto Repeat
Mode Dec
Hex 254 126
FE 7E
Mode
Mode
Sets key press repeat mode to typematic or hold. In typematic mode if a key press is held, the key value is
transmitted immediately, then 5 times a second after a 1 second delay. In hold mode, the key down value is
transmitted once when pressed, and then the key up value is sent when the key is released. Default is typematic.
Mode 1 byte, 1 for hold mode or 0 for typematic
7.7 Auto Repeat
Mode Off Dec
Hex 254 96
FE 60
Turns auto repeat mode off. Default is on (typematic).
7.8 Assign Keypad
Codes Dec
Hex 254 213
FE D5
Key Down Key Up
Key Down Key Up
Assigns the key down and key up values sent to the host when a key press is detected. Defaults are shown below
and can be reset by setting all values to 255.
Key Down 16 bytes, key down values
Key Up 16 bytes, key up values
Table 25: Default Key Down Values
Key Down
A(65) B(66) C(67) D(68)
E(69) F(70) G(71) H(72)
I(73) J(74) K(75) L(76)
M(77) N(78) O(79) P(80)
Table 26: Default Key Up Values
Key Up
a(97) b(98) c(99) d(100)
e(101) f(102) g(103) h(104)
i(105) j(106) k(107) l(108)
m(109) n(110) o(111) p(112)