Cleanup, Cleanup - latex materials, 16 cleanup - latex materials – Wagner ProCoat User Manual

Page 16: Safety cleanup, You will need

English

Safety

cleanup

You will need:

• A water source that can be delivered with

a garden hose (latex materials only)

• Mineral spirits if using oil-based material

• Empty waste container

• A container with warm, soapy water

• When using latex material, clean sprayer and components with warm, soapy water. For oil based material use mineral

spirits. Never use mineral spirits with latex materials

• NEVER use gasoline to clean sprayer

• Dispose of used cleaning solution properly

• Thorough cleaning and lubrication of sprayer is important to ensure proper operation after storage

• If you flush your sprayer with mineral spirits, repeat cleanup instructions using warm, soapy water.

Follow these steps whenever cleaning with mineral spirits:

• If spraying or cleaning with oil-based materials, the spray gun must be grounded while preparing the spray hose or

cleaning.

• Ground the gun by holding it against the edge of a metal container while purging. Failure to do so may lead to a static

electric discharge which may cause a fire.

• Always flush spray gun at least one hose length from spray pump.

• If collecting flushed solvent in one gallon metal container, place it into an empty five gallon container, then flush.

• Area must be free from vapors.

• Follow all cleanup instructions.

Cleaning notes - read before cleaning

Cleanup - Latex materials

Follow these steps if you used latex materials and if you have a garden hose available. If you do not

2. Remove the spray tip and

place into container filled

with warm, soapy water.

3. Place the suction tube and return tube

into an empty waste container.

4. Using a garden hose, rinse off the

suction tube, return tube and inlet filter.

Empty the waste container of all fluids.

MINERAL

SPIRITS

PRIME