Wagner ProCoat - Manual (Page 12)

English 12
Safety Spraying
troubleshooting -
clear the
Spray tip
You will need:
• Scrap material / cardboard
Do not attempt to unclog or clean
the tip with your finger. High
pressure fluid can cause injection
injury.
1. Lock the spray gun. Turn the power
OFF.
2. Rotate reversible spray tip 180 degrees to
cLeAn position (arrow pointing toward the rear
of the spray gun.
note: If spray tip is
difficult to rotate, relieve
pressure by turning PRIME/
SPRAY knob to PRIME
and squeeze trigger while
pointing at scrap material/
cardboard. Release trigger
and try rotating spray tip
again.
3. Turn the PRIME/SPRAY
knob to SPRAY - MINIMUM
PRESSURE. Turn power
ON.
4. Unlock the spray gun. 5. Point at a piece of scrap material
/ cardboard and squeeze trigger
until material comes out in a high
pressure stream. Release the
trigger and lock the spray gun.
6. Reverse the spray tip so the arrow
points forward. Resume spraying.
1 2
l
O OFF
CLEAN ROLL CLEAN ROLL
MAX MAX
3 4 5 6
l
O
ON