Wagner Power Painter Pro with EZ Tilt - Manual (Page 16)

English
16 © Wagner Spray Tech. - All Rights Reserved
Cleanup
(remote suction hoses / backpack kit)
You will need:
• Waste container
• Cleaner nozzle
• Warm soapy water if you sprayed latex materials
• Mineral spirits if you sprayed oil-based materials
Make sure you clean the sprayer in a well-
ventilated area whenever cleaning with
flammable solvents.
The sprayer contains electrical parts. DO nOT
submerge the sprayer into any liquids.
Cleanup (remote suction hoses / backpack kit):
1. Unplug the sprayer.
Remove the remote suction set from the material
container / backpack assembly and submerge into
a container of the solvent appropriate to the type of
material you sprayed.
2. Plug in the sprayer.
Squeeze the trigger and spray into a waste container until
the cleaning solution comes through the sprayer for a
couple of minutes.
3. Unplug the sprayer.
Remove the remote suction set housing from the sprayer.
Remove smaller return hose from suction set housing.
4. Disassemble the remote suction set housing.
Clean all parts by hand using the cleaning brush and the
appropriate cleaning solution.
Reassemble.
note: If you used the backpack kit, be sure to clean the
suction tube and the inside of the backpack by hand using
the appropriate cleaning solution.
5. Latex materials only - Thread the cleaner nozzle onto a
garden hose.
6. Latex materials only - Insert nozzle into one of the
remote suction hoses.
Place the other end of the hose into a waste container.
Turn on the water and flush the hose until clean. Repeat
for the other hose.
7. Reattach the smaller return hose to the dual hose fitting.
Follow steps 4-10 in Cleanup - Cup Mode (page 14).
1
2
3
4
7
5 6