Wagner Power Painter Pro with EZ Tilt - Manual (Page 14)

English
14 © Wagner Spray Tech. - All Rights Reserved
Cleanup (cup mode)
You will need:
• Waste container
• Cleaner nozzle and lubricant
• Warm soapy water if you sprayed latex materials
• Mineral spirits if you sprayed oil-based materials
Make sure you clean the sprayer in a well-
ventilated area whenever cleaning with
flammable solvents.
The sprayer contains electrical parts. DO nOT
submerge the sprayer into any liquids.
Cleanup (cup mode):
1. Unplug the sprayer. Pour the remaining material back
into the original container.
Rinse the inside of the cup with the appropriate cleaning
solution.
2. Remove the suction tube and filter assembly.
3. Disassemble the suction tube and filter assembly.
note: The threads on the bottom housing (a) are left-
handed. You will need to turn the bottom housing to the
right in order to remove it.
4. Turn the tip nut counter-clockwise and remove the
adjustable spray tip assembly.
Pull the atomizer valve out, being careful not to lose it.
5. Turn the locking nut counterclockwise until it is removed.
6. Slide the pump housing off the sprayer.
7. Remove the spring and piston from the pump assembly.
(continued on next page)
1
2
(a)
3
4
7 5 6