MagTek MICRImage - Manual (Page 9)

1
SECTION 1. COMMANDS OVERVIEW
This manual describes the use of all the commands and programmable options available for the
MICRImage Reader. The MICRImage commands can be classified into two general groups:
Configuration Commands and Operational Commands.
CONFIGURATION COMMANDS
As the name implies, these commands are used to configure the MICRImage Reader. These
commands can also be accessed using Insta-change checks and the MICRbase Setup Program for
Windows (see below). Additionally, all the parameters and options controlled by the
configuration commands can be factory set as specified by the user when ordering.
The current list of configuration commands follows for the standard unit (see Section 2 for a
complete description of these commands):
• SWA – Switch A command
• SWB – Switch B command
• SWC – Switch C command
• SWD – Switch D command
• SWE – Switch E command
• SWF – Switch F command
• HW – Hardware command
• FC – Format Change command
• SA – Save Configuration command
• PR12 – Filename Configuration
• PR20 – PR29 - Snippets
• PR30 – PR33 - Doc Size Limits
• PR34 – PR35 – MICR Line Technical
Options
The current list of configuration commands follows for the Ethernet and Modem Options (see
Section 5 for a complete description of these commands):
• PR0 – MICR IP Address Fixed Value
• PR1 – MICR IP Address Source
• PR2 – MICR IP Subnet Mask Fixed
Value
• PR3 – MICR Subnet Mask Source
• PR4 – Gateway IP Address Fixed Value
• PR5 – Gateway IP Address Source
• PR6 – FTP IP Address Fixed Value
• PR7 – FTP IP Address Source
• PR8 – FTP User ID Fixed Value
• PR9 – FTP User ID Source
• PR10 – FTP Password Fixed Value
• PR11 – FTP Password Source
• PR13 – DNS1 IP Address
• PR14 – DNS2 IP Address
• PR15 – DMS IP Address Source
• PR16 – Phone #
• PR17 – User ID
• PR18 – User Password
• PR19 – FTP File Directory
OPERATIONAL COMMANDS
Operational commands provide access to additional parameters and options that control the
operation of the MICRImage reader.
The current list of general operational commands follows (see Section 3 for a complete
description of these commands):
• VR – Version command
• RS – Reset command
• LE – LED command
• DM – Disable MICR command
• EM – Enable MICR command
• BLK – Block Command
• UNBLK – Unblock Command