MagTek MICRImage - Manual (Page 46)

MICRImage Check Reader
38
NETWORK DEBUG COMMANDS
PING – Send ECHO Packet Command
The PING command allows the user to check on the Ethernet or Modem connection by having the
MICRImage send a number of ECHO packets to the FTP server and measure the time required for a
response back.
PING
The MICRImage responds:
Pinging FTPSRV with 64 bytes of data
Reply rcvd from [192.11.12.13]: time=3ms.
Reply rcvd from [192.11.12.13]: time=2ms.
Reply rcvd from [192.11.12.13]: time=1ms.
Reply rcvd from [192.11.12.13]: time=2ms.
Packets: Sent 4, Rcvd 4
Optionally you can specify the IP address in the command. For example:
PING 192.12.11.123
ED – Ethernet Debug Command
Provides information about the Network parameters currently being used by the MICRImage. This is
especially useful when verifying the dynamic configuration using DHCP. Also can provide debug trace
for further troubleshooting. The list of ED commands is as follows:
ED
OUTPUT NETWORK INFO
ED1 ENABLES FTP DEBUG MESSAGES
ED2 ENABLES PPP DEBUG MESSAGES
ED3 ENABLES BOTH FTP AND PPP DEBUG
For example, the MICRImage responds to ED with:
Link detected.
CHKSCN -> MAC=001A10000002
CHKSCN -> IP addr=192. 37. 11.220, Subnet mask=255.255.255.0
ROUTER -> IP addr=192. 37. 11. 70, Subnet mask=255.255.255.0
FTPSRV -> IP addr=192. 37. 12.205, Subnet mask=255.255.255.0
DHCPSV -> IP addr=192. 37. 11. 20