MagTek MINI MICR WEDGE - Manual (Page 54)

MINI MICR WEDGE with 3-Track MSR
46
Determine if any of the conditions described above are true:
◊ If yes, rectify and continue to step 02.
◊ If no, continue to step 15.
07
Missing characters
Possible cause for this problem is:
• Feeding the check - When feeding the check, make sure that the MICR line is at the bottom
and the printed side of the check is facing the MagTek logo on the MICR Reader.
Determine if the above condition is true:
◊ If yes, rectify and continue to step 02.
◊ If no, continue to step 08.
08
Character Rate
Possible cause for this problem is:
• The character rate at which the MICR Reader is sending may be too fast. Check to see if the
last few characters in the data message are consistently missing.
Determine if the above condition is true.
◊ If yes, continue to step 18.
◊ If no, continue to step 15.
09 Incorrect
Format
Possible causes for this problem are:
• Incorrect format number - the current check data format in the MICR Reader is not the
desired format. Verify/change the format. Use the FC command (refer to Section 4).
• Incorrect message format - the current message format in the MICR Reader is not the desired
format. Verify/change the message format. Use the SWB command (refer to Section 4).
Determine if any of the conditions described above are true:
◊ If yes, rectify and continue to step 02.
◊ If no, continue to step 18.